Categories

System glitches and false alarms can be frustrating, and even worse, could prevent your home’s security from doing its job effectively. Thankfully, most issues, from dead batteries to false alarms, are simple to correct. Take a look at our tips for troubleshooting your home alarm system in Auburn. We’ll help you keep your household protected and your system operating properly.

Test Your Home Security System In Auburn

One of the most sensible ways to troubleshoot your property’s security is to test it! The latest systems let you place them in test mode to keep you from initiating an emergency call. After switching to test mode, do the following:

• Activate your system as you normally would when you exit your home.
• Open a window or door that has a contact sensor, or test other sensors. Shut the door or window once you’re done so it doesn’t trigger the alarm when you switch the system back on.
• Permit the alarm to go off for 60 seconds to make sure a signal is dispatched to the security company and an entry is made in the alarm activity log.
• Continue testing devices as needed
• Check the alarm’s activity log to confirm functionality.

Don’t worry, monitoring professionals can see that your alarm system is undergoing a test. Just be sure to turn test mode off when you’re done. It’s smart to test once a month or whenever you change your home’s phone or internet connectivity.

Inspect The Position And Condition Of Motion Sensors

Although an integral part of your alarm system, motion sensors are notorious for false alarms. Prevent them with a few straightforward troubleshooting steps.

• Conduct a visual inspection. Is there anything that could move within range of the sensor, like a window treatment blown in a breeze?
• Is the sensor dirty? Grime, dirt, and cobwebs can cause issues. Ensure the face is clean.
• Does the motion detector offer pet immunity you can turn on? Some sensors can be configured to disregard pets weighing as much as 100 pounds.
• When was the battery replaced? A low battery might impact performance or result in false alarms.
• Is a heat source affecting the sensor? Excessive heat from a fireplace, direct sun, or something else can trigger an alarm.

Keep Batteries Ready And Pay Attention To Low Battery Warnings

One helpful perk of modern home security systems is that they’ll tell you when batteries are getting low. If your system uses a control panel or smartphone app, you’ll typically discover messages there. Depending on the alarm, you may hear an occasional beep when batteries are running out. 

Motion detectors, smoke detectors, contact sensors, and other wireless components have batteries that will have to be replaced every 1 to 2 years. It’s wise to keep batteries on hand and create a replacement schedule. Many systems also include a rechargeable backup battery for the central control panel. This battery helps keep your system operating if you lose power and should charge back up once the electricity is working again. If it fails to recharge, you will need to replace it.

Troubleshooting Is Effortless With ADT Home Security In Auburn 

As the foremost name in home security, ADT builds systems that offer unsurpassed functionality and convenience. Accessing test mode is easy through the ADT+ app or MyADT.com, and you’ll always receive alerts when a sensor battery is running low. Contact Secure24 Alarm Systems, an authorized ADT dealer, to get more details and design a system perfectly suited to your Auburn home. Place a call to (334) 219-8276 or submit our form today!